Hors Stock Appeler pour vérifier Channel strips Empirical LabsEL-RX Docderr EMPI3565C9 1 320 € Frequency Response – 3 Hz to 180 kHz on eq section (-3dB points). Dynamic Range – 120 dB from maximum output (.5%THD soft clipping) to minimum output. Noise floor with Mix on 0 is typically – 91dBu. Distortion – between .0006% and 10% at 1KHz, depending on mode and settings. I/O – Maximum Input before hard clipping – +22dBm, “ Line In” mode.... Voir
Hors Stock Appeler pour vérifier E.Q.'s & De-essers Empirical LabsELQ Lil freq EMPI6E6EC7 3 200 € Freq. Response - 5 Hz to 140 kHz on transformerless inputs and outputs.Transformer Output response is 10 Hz to 110 kHz .Dynamic Range - 120 dB from maximum output (.1% clipping) to minimum output. Greater than 110 dB signal to noise.Distortion Ranges between .00056% and .005% depending on mode and settings. DS section has THD < .005%.DC coupled Input... Voir
Hors Stock Appeler pour vérifier E.Q.'s & De-essers Empirical LabsEL-DS Derresser EMPIFEABEE 625 € Frequency Response – 3 Hz to 120 kHz (-3dB points).Dynamic Range – 115 dB from maximum output (.5%THD soft clipping) to minimum output. Transformerless noise floor typically – 93dBu.Distortion – Ranges between .0035% and .01% depending on mode and settings. I/O – DC Coupled input and outputs. Input Balanced, Output single ended but with balanced... Voir
Hors Stock Appeler pour vérifier Préamplis Empirical LabsEL9 Mike-E EMPIABB194 2 900 € Freq. Response is 3 Hz to 200 kHz on (No CompSat). CompSat is 3Hz - 150Khz. Optional Transformer output is 6Hz-80kHz. Signal to Noise - 130 dB signal to Noise.at 40dB gain. Maximum output is +28dBu. Distortion Ranges between .0006% and 15% depending on mode and settings. Transformer coupled Input, Active and Transformer Outputs... Voir
Hors Stock Appeler pour vérifier Compresseurs gates limiteurs Empirical LabsEL8X Distressor EMPIB54DA9 2 000 € Freq. response is 2 Hz to 160 kHz in clean audio mode (+0, -3 dB). Response is shaped in distortion modes (Dist 2, Dist 3). Dynamic range 110 dB from max. output to min. output in 1:1 mode. Greater than 100 dB signal to noise in distort 3 mode. Distortion ranges between .02% and 20% depending on distortion mode and release times set on... Voir
Hors Stock Appeler pour vérifier E.Q.'s & De-essers Empirical LabsEL7X Fatso EMPI6A3AFF 2 890 € Freq. Response is 2 Hz to 60 kHz in clean audio mode (+0, -3 dB).Dynamic Range 110 dB from maximum output (20%THDsoft clipping) to minimum output. Greater than 100 dB signal to noise.Distortion Ranges between .06% and 20% depending on mode and settings.DC coupled Input and OutputsHigh quality audio caps used internally. Compressor Time Constants - Attack... Voir
Hors Stock Appeler pour vérifier Channel strips Rupert Neve DesignsShelford Channel RUPEDA7B75 3 900 € MIC PREAMPINPUT IMPEDANCE 2200 Ohm MAXIMUM INPUT +21.5 dBu from 150 Hz to 22 kHz +8 dBu 20 Hz to 22 kHz NOISE Un-weighted, 22 Hz-22 kHz, source impedance 150 Ohm balanced. Main Out @ unity gain -100.9 dBu -6 dB Out @ unity gain -106.6 dBu +30 dB gain (Main Out) -91.37 dBu +66 dB Gain (Main Out) -64.1 dBu Equivalent Input Noise -121.37 dBu FREQUENCY... Ajouter au panier
Hors Stock Appeler pour vérifier Ampli Casques Rupert Neve DesignsRNHP RUPE24462D 700 € Maximum Input Levels "A" XLR I/P: +22.8 dBu @1kHz "B" RCA I/P: +14.7dBu @1kHz, "C" 3.5mm I/P: +3.3dBu @1kHz Output Power: As measured with typical headphones, Z=44 Ohms: 3.617 VAC RMS @1kHz = 300mW RMS 16 Ohms typical Load: 1.933 VAC RMS @1kHz = 230mW RMS 150 Ohms typical Load: 5.108 VAC RMS @1kHz = 175mW RMS Output Impedance .08 Ohms @ 1KHz, 16-150... Ajouter au panier
Hors Stock Appeler pour vérifier D.I. Rupert Neve DesignsRNDI-S RUPE4A776C 500 € NOISE Measured Output, un-weighted, 22 Hz - 22 kHz, source impedance 150 Ohm. Better than -110 dBV INPUT IMPEDANCE Instrument Setting: 2.2 Meg Ohm 3.5 mm Input: 95 Kilohm OUTPUT IMPEDANCE Less than 40 Ohms FREQUENCY RESPONSE +/- 0.25 dB from 30 Hz - 63 kHz +/- 1 dB from 12.5 Hz - 120 kHz -3 dBu @ 5 kHz MAXIMUM INPUT LEVEL Instrument = +20.5 dBu MAXIMUM... Ajouter au panier
Hors Stock Appeler pour vérifier D.I. Rupert Neve DesignsRNDI RUPE4453EB 300 € Noise: Measured Output, un-weighted, 22Hz-22kHz, source impedance 150 Ohms to 10K Ohms Better than -110dBV Input Impedance Instrument Setting: 2.2 Meg Ohm Speaker Setting: 200k Ohm Output Impedance Less than 40 Ohms Frequency Response +/- 0.25dB from 25Hz - 44kHz +/- 1dB from 12.5Hz - 63kHz -3dBu @ 92kHz Maximum Input Level Instrument = +21dBu... Ajouter au panier
Hors Stock Appeler pour vérifier Préamplis Rupert Neve DesignsRMP-D8 RUPEFB29AC 6 300 € NOISE 150 Ohm Balanced Source, AES Output, 22 Hz to 22 kHz, un-weighted, +60 dB Gain.-91 dBFSUNITY GAIN-110 dBFSFREQUENCY RESPONSE0 dBu, Unity Gain, 96 kHz30 Hz to 45 kHz +/- 0.2 dB10 Hz -3 dBINPUT IMPEDANCE5.5K OhmGAIN0 to 60 dB in 1 dB stepsHIGH PASS FILTER-3 dB @ 80 Hz, 12 dB/Octave SlopePAD-10 dBSIGNAL TO NOISE RATIO84.4 dBDYNAMIC RANGE 110 dBMAXIMUM... Ajouter au panier
Hors Stock Appeler pour vérifier Racks modulaires & Alimentations Rupert Neve DesignsR10 RUPE7CE3C4 1 150 € DC VOLTAGE TO UNITS +/-16VDC and +48VDC for phantom power MAX CURRENT 2650mA total (2400mA modules and 250mA for phantom power) POWER REQUIREMENTS 100-240VAC, 50/60Hz, 50 Watts WEIGHT 14lbs DIMENSIONS 19” long x 7.5”deep x 5.5” high Ajouter au panier
Hors Stock Appeler pour vérifier E.Q.'s & De-essers Rupert Neve DesignsPortico 5045 RUPERT418P 1 880 € Threshold Continuously variable from -20 to 10dBu Depth Continuously variable from 0 to 20dBu Time Constants Peak Mode A: 50mS B: 100mSC: 200mSD: 750mSE: 1.5SF: 3S RMS Mode Time Constant data collected using 10dB bursts. Attack: fixed 20mS Release: A: 20mSB: 200mSC: 1SD: 2SE: 5SF: 30S Maximum Output Level: +25dBu Total Harmonic Distortion and Noise... Ajouter au panier
Hors Stock Appeler pour vérifier Channel strips Rupert Neve DesignsPortico 5017 RUPERT851I 1 300 € Dimensions 7.5" (deep) x 6.5" (wide) x 2" (high) Frequency Response Main Output, no load, -0.2 dB @ 10 Hz -3 dB @ 160 kHz Noise Measured at Main Output, unweighted, 22Hz-22kHz, Terminated 150 Ohms. With gain at unity better than -100 dBu With gain at 66 dB better than -62 dBu Equivalent Input Noise better than -128... Ajouter au panier
Hors Stock Appeler pour vérifier Compresseurs gates limiteurs Rupert Neve Designs5254 RUPEWYD3XO 3 800 € Input Impedance 10 kΩOutput Impedance 40 ΩMaximum Input Level (+4dBu Selected) +26.7 dBu typicalMaximum Output Level +26.7 dBu typicalNoise (22 Hz – 22 kHz BW) -104 dBu typicalFrequency Response (10 Hz to 120 kHz) +/- 0.25 dB typicalTHD+N @1 kHz @ Maximum Level (22 Hz – 22 kHz BW) 0.0008% typicalCompressor Noise SpecificationsNoise @ 0dB Make-Up Gain (22... Ajouter au panier