E.Q.'s & De-essers - Audio & Sonorisation

E.Q.'s & De-essers

Affichage 1-25 de 42 article(s)

Disponible immédiatement

E.Q.'s & De-essers

DBX
2031

DBXEGA249S

540 €

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
ZODIAK-ICX

BUZZ7GXBNI

2 000 €

Maximum Input Level +25dBu Maximum Output Level +29dBu. Frequency Response (Lo and Hi Cut switched out) 3Hz to 200kHz (+/-1dB). Harmonic Distortion 0.009% 100Hz to 10kHz. Output Noise (all bands in set flat) -88dBu A weighted Channel to Channel Crosstalk below noise Indicators Peak level LED set to +22dBu. Power On LED. Rear Panel Connectors Input-XLR3F,...

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
ZODIAK-DCX

BUZZ37C9TA

2 290 €

Appeler pour vérifier

E.Q.'s & De-essers

Tierra audio
2x Icicle Equalizer Take 2
MATCHED

TIERTJYBTZ

3 300 €

Sortie ligne : Sortie maximale : +26 dBu 0,1% THD. Distorsion : sortie 20 dBu, pas plus de 0,05 % de 40 Hz à 10 kHz. Réponse en fréquence : 20 Hz à 20 kHz (-0,5 dB). Distorsion harmonique : sortie 20 dBu, 60 Hz 0,03 %, 1 kHz 0,01 %, 10 Khz 0,05...

Appeler pour vérifier

E.Q.'s & De-essers

Tierra audio
Icicle Equalizer Take 2

TIERY3AJ8T

1 680 €

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
Tonic

BUZZMJTJ63

935 €

Maximum Input Level +23dBu Maximum Output Level +26dBu into 3k ohm load Frequency Response EQ set flat 17Hz to 175kHz (+1dB, -3dB) Harmonic Distortion measured +10dBu output level 0.08% @ 100Hz, 0.02% @ 1kHz, 0.005% @ 10kHz Signal to Noise Ratio -88dB A wtg, input shorted Input Impedance 20k ohms approx balanced Indicators Single LED overload indicator...

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
Zodiak ICT Black

BUZZ5LIJKS

1 880 €

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
Zodiak ICT Silver

BUZZNVQYDO

1 880 €

Maximum Input Level +25dBu Maximum Output Level +29dBu.Frequency Response (Lo and Hi Cut switched out) 3Hz to 200kHz (+/-1dB).Harmonic Distortion 0.009% 100Hz to 10kHz.Output Noise (all bands in set flat) -88dBu A weightedChannel to Channel Crosstalk below noiseIndicators Peak level LED set to +22dBu. Power On LED.Rear Panel Connectors Input-XLR3F,...

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
REQ-2.2 ME Black

BUZZF44FM8

7 745 €

Frequency Response measured with all eq bands on and set flat, Saturation and HPF off = 5Hz to 125kHz +0.2/-3dB Harmonic Distortion at +10dBu signal level Saturation OFF 100Hz 0.007%...1kHz 0.004%...10kHz 0.007%...100kHz 0.013% Saturation ON POS-1 20Hz 1.5%...100Hz 0.07%...1kHz and up 0.01% Saturation ON POS-2 20Hz 1.5%...100Hz 0.14%...1kHz and up 0.01%...

Appeler pour vérifier

E.Q.'s & De-essers

Buzz Audio
REQ-2.2 ME Silver

BUZZXAE9D9

7 745 €

Appeler pour vérifier

E.Q.'s & De-essers

Tube Tech
PE 1C

TUBE9E327E

2 870 €

Impedance Input: 600 Ohm Output < 60 Ohm Frequency response @ -3dB 5 Hz to 40 kHz Distortion THD+N @ 40Hz 0 dBU 0,15 % +10 dBU 0,15 % Max. output: +26 dBU - < 1 % Max. input: +21 dBU - < 1 %...

Appeler pour vérifier

E.Q.'s & De-essers

Tube Tech
ME 1B

TUBEBF8D0D

2 975 €

Impedance Input: 600 Ohm Output < 60 Ohm Frequency response @ -3dB 5 Hz to 40 kHz Distortion THD+N @ 40Hz 0 dBU 0,15 % +10 dBU 0,15 % Max. output: +26 dBU < 1 % Max. input: +21 dBU < 1 % NoiseRg=200 Ohm 22 Hz-22 kHz < -80 dBU CCIR-468-4 < -70 dBU CMMR@ 10 kHz < - 60 dB...

Appeler pour vérifier

E.Q.'s & De-essers

Tube Tech
HLT2A

TUBE6C4A59

3 445 €

Input impedance: >10 kÎ© Output impedance: < 60Î© Frequency response (-3dB): 5 Hz - 55 kHz Distortion (THD+n @ 40 Hz):0 dBU: 10 dBU: Max output (1% THD+n): > Max input (1% THD+n): < 0,10 % < 0,10 %+26 dBU> +25 dBU Noise (Rg=200Î©):22Hz-22kHz: CCIR-468-4: < -85 dBU< -75 dBU CMRR (@ 10kHz):...

Appeler pour vérifier

E.Q.'s & De-essers

Radial Engineering
Q3

RADIAL757W

690 €

Audio circuit type: Coil/Capacitor/Resistive Boost and Cut Filters Frequency response: 20Hz-20KHz +/- 1dB in non EQ positions Dynamic range: 112dB Noise floor: -90dBu filters off (-87dBu filters on) Maximum input: +20dBu Total harmonic distortion:...

Appeler pour vérifier

E.Q.'s & De-essers

Empirical Labs
ELQ Lil freq

EMPI6E6EC7

3 200 €

Freq. Response - 5 Hz to 140 kHz on transformerless inputs and outputs.Transformer Output response is 10 Hz to 110 kHz .Dynamic Range - 120 dB from maximum output (.1% clipping) to minimum output. Greater than 110 dB signal to noise.Distortion Ranges between .00056% and .005% depending on mode and settings. DS section has THD < .005%.DC coupled Input...

Appeler pour vérifier

E.Q.'s & De-essers

Empirical Labs
EL-DS Derresser

EMPIFEABEE

625 €

Frequency Response – 3 Hz to 120 kHz (-3dB points).Dynamic Range – 115 dB from maximum output (.5%THD soft clipping) to minimum output. Transformerless noise floor typically – 93dBu.Distortion – Ranges between .0035% and .01% depending on mode and settings. I/O – DC Coupled input and outputs. Input Balanced, Output single ended but with balanced...

Appeler pour vérifier

E.Q.'s & De-essers

Empirical Labs
EL7X Fatso

EMPI6A3AFF

2 890 €

Freq. Response is 2 Hz to 60 kHz in clean audio mode (+0, -3 dB).Dynamic Range 110 dB from maximum output (20%THDsoft clipping) to minimum output. Greater than 100 dB signal to noise.Distortion Ranges between .06% and 20% depending on mode and settings.DC coupled Input and OutputsHigh quality audio caps used internally. Compressor Time Constants - Attack...

Appeler pour vérifier

E.Q.'s & De-essers

SPL
De-Esser

SPLDTV5SJR

600 €

Analog inputs & outputs; XLR & TRS Jack (balanced)Maximum input and output gain22 dBu Input impedance22 kΩ Output impedance< 600 Ω Common mode rejection (1 kHz)> 80 dB Frequency range (-3 dB)20 Hz – 50 kHz THD + N (0 dBu, 10 Hz – 22 kHz)0.002 % Crosstalk (1 kHz)-90 dBu Noise (A-weighted)-98 dBu Dynamic range120 dB Internal Linear Power...

Appeler pour vérifier

E.Q.'s & De-essers

SPL
DeS

SPLDJT32WM

310 €

Input & Output; balancedMaximum input & output gain21 dBu Input impedance20 kΩ Output impedance150 Ω Common mode rejection-82 dB Frequency range (-3 dB)10 Hz – 100 kHz THD & N (0 dBu, 10 Hz – 22 kHz)0,03 % Noise (A-weighted)-92.3 dB Dynamic range113 dB Dimensions & WeightUnit weight0.65 kg Shipping weight (incl. packaging)0.7 kg

Appeler pour vérifier

E.Q.'s & De-essers

SPL
Tube Vitalizer

SPLTUB904U

1 900 €

Analog inputs & outputs; XLR & TRS Jack (balanced)Maximum input gain 24 dBu Input impedance 22 kΩ Output impedance 600 Ω Common mode rejection (1 kHz) 70 dB Frequency range (-3 dB, tube section off) 10 Hz – 100 kHz Frequency range (-3 dB, tube section on) 30 Hz – 100 kHz THD + N (0 dBu, 10 Hz – 22 kHz) 0.002 % Noise...

Appeler pour vérifier

E.Q.'s & De-essers

SPL
Stereo Vitalizer Mk2-T

SPLSTE740V

870 €

Analog inputs & outputs; XLR & TRS Jack (balanced)Maximum input gain22 dBu Input impedance22 kΩ Output impedance600 Ω Common mode rejection (1 kHz)85 dB Frequency range (-3dB)10 Hz – 100 kHz THD + N (0 dBu, 10 Hz – 22 kHz)0.0019 % Noise (A-weighted)-99 dBu Dynamic range121 dB Internal Linear Power Supply with Toroidal TransformerOperating voltage...

Appeler pour vérifier

E.Q.'s & De-essers

API
560 Discrete 10 Band Graphic EQ

APISLO830Z

823 €

Number of Bands:10Filter Type:Proportional Q, Octave entered, Continuously Adjustable LevelFilter Frequency Centers:31, 63, 125, 250, 500, 1kHz, 2kHz, 4kHz, 8kHz, 16kHzFilter Boost/Cut:+/- 12 dBFilter Slope:12 dB per Octave at full boost or cutInput Impedance:20k Resistive, BalancedOutput Impedance:Less than 85 OhmsNominal Levels:-15 to +15 dBuClipping...

Appeler pour vérifier

E.Q.'s & De-essers

Great River
THE 32EQ

GREATR100N

925 €

Low, Low-Mid, Hi-Mid, and High EQ bands with Gain and Frequency controlsLow and High Band ""peaking"" switchesEQ in/out switchHarrison's renowned High- and Low-pass filters with sweepable frequencyFilter in/out switchAn Internal jumper provides selection of the ""vintage"" feedback design, or a non-feedback option

Appeler pour vérifier

E.Q.'s & De-essers

Summit audio
FeQ-50 Passive Tube EQ

SUMMIT703T

795 €

Size and WeightHeight1.75 inches (4.44 cm)Width8.5 inches (21.59 cm)Depth8.5 inches (21.59 cm)Weight5 pounds (2.77 kg)Power ConfigurationInternal AC Supply15 watts, 115, 50 or 60 Hz (USA model)Fuse size .5 amp, slo-blo for 100/115 VFuse size .25 amp, slo-blo at 230 VSelectable FrequenciesLow Band The Low EQ band can be set for either a peak or...

Appeler pour vérifier

E.Q.'s & De-essers

AMS Neve
8803

NEVEDU118Y

1 800 €

Revered equalization circuitry derived from classic 8108 design and flagship 88RS analogue consoleHand-built and hand-wired by Neve in Burnley, EnglandÂ±20dB Input trimHigh pass filter 30Hz-300Hz, 12dB per octaveLow pass filter 3kHz-15kHz, 12dB per octaveEQ High 1.5k-18kHz, selectable Shelving/Bell, selectable Hi QEQ Mid High 0.8kHz-9kHz, Q range: 0.3 to...